Ana sayfa > Bilgi > İçerik

How To Solve The Problem Of Bending Deformation During The Extrusion Of PVC Profile Products?

Mar 14, 2023

PVC Bending deformation of profile is a common problem in extrusion process. The main causes include: uneven mouth discharge; the material is not sufficient, the shrinkage amount is not consistent; the equipment and other factors.
It is suggested to solve it from the following aspects:
1. Ensure the concentricity and level of the whole line of the extruder, and the concentricity and level of the extruder, mouth mold, shaping mold and water tank should be corrected during each replacement of the mold.
2. Carefully assemble the mouth mold before the startup, so that the clearance of all parts is consistent. If the mouth mold is uneven during the startup, the mouth mold temperature can be adjusted according to the bending direction of the mouth mold. If the adjustment of the mouth mold temperature is invalid, the plasticizer of the material can be appropriately improved.
3. Adjust the cooling system of the mold and increase the cooling water on the side of the profile under tensile stress.
4, use the method of mechanical offset center to adjust, that is, while production, while adjusting the positioning bolt in the middle of the setting mold, reverse trace adjustment according to the bending direction of the profile (using this method should be careful, and the adjustment amount should not be too large).
5. Pay close attention to the working quality of the mold, pay attention to the maintenance of the mold, and maintain and maintain the mold at any time according to the actual situation.

Soruşturma göndermek